tracker-miner stuck

tracker-miner stuck


This is a bugging issue, and it ends up consuming a good chunk of the CPU, which is identifiable by the continuously running CPU fan at high speeds. How to resolve it?

Stop the tracker miner:

    systemctl --user stop tracker-miner-fs-3.service    

Delete its current cache, reset it, and then restart it (all in one go):

    tracker3 reset --filesystem --file --rss    


Comments

Post a Comment

Popular posts from this blog

Bluetooth Error: obex connect failed with 0x53

Bluetooth Error: obex connect failed with 0x53 BlueZ is the Bluetooth protocol stack for Linux. According to it, the opcode 0x53 denotes Service Unavailable . This is a temporary error that is caused by an ongoing Bluetooth process. This could be due to some application or service (in the foreground or in the background) that is currently sending data to the same device. It could also occur if you have forgotten to close any window (or notification) pertaining to the device's Bluetooth transfer, even after the transfer has been completed (successfully or unsuccessfully). Reference: Obex Source Code
Read more

Failed to start apache2.server

Failed to start apache2.server (while booting or otherwise)      sudo systemctl status apache2      results in the following message: × apache2.service - The Apache HTTP Server       Loaded: loaded (/usr/lib/systemd/system/apache2.service; enabled; preset: enabled      Active: failed (Result: exit-code) since Fri 2025-08-29 08:17:06 IST; 1h 33min ago        Docs: https://httpd.apache.org/docs/2.4/         CPU: 95ms Aug 29 08:17:02 mfcarlo-HP-Pavilion-dv6-Notebook-PC systemd[1]: Starting apache2.server - The Apache HTTP Server... Aug 29 08:17:06 mfcarlo-HP-Pavilion-dv6-Notebook-PC apachectl[1768]: apache2: Syntax error on line 146 of /etc/apache2/apache2.conf: Syntax error on line 3 of /etc/apache2/mods-enabled/php8.1.load: Cannot load /usr/lib/apache2/modules/libphp8.1.so into server: /usr/lib/apache2/modules/libphp8.1.so: cannot open shared object file: No such file or directory Aug...
Read more

Decrypting PGP-encrypted messages

Decrypting PGP-encrypted messages Save the PGP-encrypted message as a text file (e.g. abc.txt). The PGP-encrypted message is usually enclosed within these two placeholders: -----BEGIN PGP MESSAGE----- -----END PGP MESSAGE----- If not, then include them in the text file, at the start and at the end, respectively. This is very important. Then, run the following command:      gpg --decrypt abc.txt      You will be prompted for the GPG passphrase. Enter it. Upon success, the decrypted message will be printed on the console.
Read more